no smoke oil for TVR In small two-stroke engines
An example is lubricating oil for four-stroke or four-cycle internal combustion engines such as those used in portable electricity generators and "walk behind" lawn mowers. Another example is two-stroke oil for lubrication of two-stroke or two-cycle internal combustion engines found in snow blowers, chain saws, model air planes, gasoline powered gardening equipment like hedge trimmers, leaf blowers and soil cultivators. Often, these motors are not exposed to as wide service temperature ranges as in vehicles, so these oils may be single viscosity oils.
In small two-stroke engines, the oil may be pre-mixed with the gasoline or fuel, often in a rich gasoline:oil ratio of 25:1, 40:1 or 50:1, and burned in use along with the gasoline. Larger two-stroke engines used in boats and motorcycles may have a more economical oil injection system rather than oil pre-mixed into the gasoline. The oil injection system is not used on small engines used in applications like snowblowers and trolling motors as the oil injection system is too expensive for small engines and would take up too much room on the equipment. The oil properties will vary according to the individual needs of these devices. Non-smoking two-stroke oils are composed of esters or polyglycols. Environmental legislation for leisure marine applications, especially in Europe, encouraged the use of ester-based two cycle oil.
Źródło: https://en.wikipedia.org/wiki/Motor_oil
Is handwritten repair a good idea?
Often our cars are accidents and then it is necessary to repair. Many of us are doing it on their own, however, such a solution for many reasons may not be a bad idea. Why is it like that? When we repair all by yourself, we can never be sure that we can deal with failure. We can not be confident that the repair will be successful, and if you're stuck at a standstill, the situation may cause us many problems. Good workshops give us confidence that the car will be repaired, and often a guarantee that will work for a long time, and when it breaks down, however, parts will be replaced at the expense of the mechanical plant. It is much safer solution.
Car Parts - original or not?
As you know, the original car parts can sometimes be very expensive, especially if we think about replacing parts in the car with the high-end class. Many people are looking for savings decides to invest in a used auto parts or replacements. Whether in this case the higher the price of a higher quality product and whether deciding on a replacement for a mistake? It actually depends on the individual case. Sometimes it may be that the replacement is just as valuable as the original part, and it is not necessary to install the original to the efficient operation of our car. However, there are also cases in which the replacement is very fast operation due to the lower quality of the product and must again replace the part.